OK, here's the agreement: if you want to build a hi-fi quality, image sedative is not optional, this is mandatory.
Why?
Let me ask you a question: Would you listen to music or the road noise? Do you want your badge to be quiet, or when the bell hits bottom? Want to hear your tires, or want to hear the music?
I know that I feel the music, and as such I have never done a real car stereo without the use of sound absorbing material.
Therefore,with all that said, let's look at soundproofing.
Soundproofing is available in many forms, but the two main types are spray on, and Mat.
Treatment of sedative is in both a spray paint spray paint bucket or a large. The spray cans are ideal for small jobs, but if you're going to go crazy with the killing, you want to buy in large quantities. When you buy in bulk, you need a voice for a couple of lights. Normally the large bucket of noise purchasedsedative. This type of sound absorbing material that works best for tight areas, and where you want a deadly mid-size sound.
The second type of insulation is covered with an adhesive sheet on the back of the magazine. This killing is hard work, but much more effective the spray-on type. It is normally used on larger areas or more sedation is needed.
Because the acoustic treatment can be expensive, fancy, where to installAnd 'the most effective. For this number, take a trip by car with the radio. Listening to the place where the noise comes mostly from the vehicle. The main places that I'm writing on the wheel wells, firewall (of course), the doors, the roof of the trunk under the rear seats and center console.
SO! Check out these sites, make sure that at any other location where the noise is due out, and begin to understand how much material you need.
This rule should be obviousbut the material more than you think you need. The reason is that when you install the device you want to listen to a second, only this time with the music on. Will certainly rattles are not marked before. You will probably also some places where you want to find bulk insulation.
When playing music, noise and distortion are your biggest enemies. Soundproofing go far to show thatproblems.
In addition to road noise, silence, sound-proofing important works to reduce rattles in the car. For example: Let's say that only certain high-mounted speakers in the doors. Why do car manufacturers are not designed for high-powered speakers for the doors, are not designed for the completion of the vibration.
To determine the vibration (which sounds horrible), just cut a ring of sound deadening material, and adjust it to where you mount the speaker. Mount the speakertop of the soundproofing material, and make sure the speaker is bolted down tight. Now you can test your new stereo. He did solve the problem? If not, try another layer of sound absorbing material.
Another trick: Have you ever noticed that some panels in the car to vibrate when certain low frequencies? Get some spray-on sound deadening material, and applies it to the back of the panel to dramatically reduce vibration. For larger panels, use of soundsedative sheets.
Another trick: if the number plate rattle, when the low blows? Do not look like an idiot does not solve the problem! Take some 'absorptive materials and applies it to the rear of the vehicle and the frame plate. Try low again, but this time will not be embarrasseer yourself when you drive through a parking lot!
Congratulations and good sound!
-Honest AEB
Related posts:
- Tips to Help Your Car Audio System Dramatically
- Best Car Audio Subwoofer – what will fulfill your expectations?
- Wholesale DJ Equipment
- Reference Sound Studios – What's the point?
- Installation Guide – iPod Adapter (Dension iPod car kits) 2
- Car Audio – How to Install Car Audio
- Should have iPod Auto Accessories
- Freeware Music Mix Software Products
- The baffle speaker – has size really matter?
- Freeware Music Mixing Software Products